Edid Learn - Tripp-Lite B002-DP1A4 Manuel De L'utilisateur

EDID Learn

KVM models with DVI-I and HDMI video output are designed to learn the
connected monitor's EDID upon power up. In the event of connecting a new
monitor to the KVM switch, a power cycle is required. To indicate to the
user that the EDID learn process is occurring, the front panel's green Port
LEDs and blue Push-Button LEDs will flash for about 10 seconds. For Dual-
Monitor KVM models, the unit will proceed to learn the EDID of the second
connected monitor after the first monitor's EDID has been read, with the
front panel LEDs flashing to indicate the process is taking place. When the
front panel LEDs stop flashing, the EDID learning process is complete.
KVM models with DisplayPort video output use built-in EDID information
that is set to HD resolution (1080p maximum), which will allow initial
operation with most DisplayPort monitors. For security purposes, EDID
learning of DisplayPort displays can be performed only by an Authenticated
Administrator. Follow the steps below to perform EDID learning on your
DisplayPort monitor:
1. This process should be started with a powered-off KVM and computer
that are not connected to each other.
2. Connect a DisplayPort cable between the computer's DisplayPort output
port and the KVM's Port 1 DisplayPort Input port.
3. Using a USB A/B device cable, connect an available USB port on the
computer to the KVM's Port 1 USB-B Input port.
4. Connect a DisplayPort monitor to the console video output port of the
KVM switch using a DisplayPort cable.
5. Connect a wired USB keyboard and mouse to the console USB keyboard
and mouse ports of the KVM switch.
Note: Keyboards and mice with internal USB hub or composite device functions
are not supported. Wireless keyboards and mice are not supported.
6. Power on the computer and KVM switch.
7. From the connected computer, download the Administration and
Security Management Tool from www.tripplite.com/support.
18-06-346-933846.indb 15
15
8/14/2018 5:53:59 PM