Power Up Self-Test - Tripp-Lite B002-DP1A4 Manuel De L'utilisateur

Miscellaneous KVM Functionality
2. Initiate the session by pressing the following hotkey command, one key
after another.
3. Upon completing the command, the mouse connected to the KVM will
stop functioning. A prompt will appear to enter the Credential ID.
4. Log in by entering the default username admin and pressing Enter.
5. Enter the default password 12345 and press Enter.
6. Select option 7 from the menu on your screen and press enter to
restore the KVM to its factory default settings.
Note: A comprehensive feature list and instructions for the Administration and Security
Management Utility can be found in the Administrator's Guide available at
www.tripplite.com/support.

Power Up Self-Test

If all front panel LEDs are on and not flashing, the Power Up Self-Test
failed and all functions are disabled. Check if any of the front panel power
selection buttons are jammed. In this case, release the jammed button
and recycle power. If Power Up Self-Test continues to fail, contact Tripp Lite
Technical Support at www.tripplite.com/support.
18-06-346-933846.indb 21
[Alt][Alt][c][n][f][g]
21
8/14/2018 5:53:59 PM