Table des Matières
Publicité
OBJ_BUCH-2473-003.book Page 11 Wednesday, November 11, 2015 2:33 PM
Symbol
Meaning
Switching On
Switching Off
On/Off switch lock-on
Releasing the On/Off switch
Low speed/impact rate
High speed/impact rate
Extraction
Tool holder
Apply a light coat of grease to the shank
end of the application tool
Key type drill chuck
*
Keyless drill chuck
*Not available in all countries.
P
Rated power input
1
E
Impact energy per stroke according to
EPTA-Procedure 05/2009
n
No-load speed
0
Ø
Drilling diameter, max.
Concrete
Steel
Wood
Weight according to
EPTA-Procedure 01:2014
Protection class
L
Sound power level
wA
L
Sound pressure level
pA
a
Vibration total value
h
K
Uncertainty
Delivery Scope
Rotary hammer, auxiliary handle and depth stop.
Application tools and other accessories shown or described
are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.
Bosch Power Tools
Intended Use
The machine is intended for hammer drilling in concrete,
bricks and masonry, as well as for light chiselling work. It is al-
so suitable for drilling without impact in wood, metal, ceram-
ics and plastic, as well as for screwdriving.
Technical Data
The technical data of the machine are listed in the table on
page 168.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries,
these values can vary.
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2011/65/EU, until
19 April 2016: 2004/108/EC, from 20 April 2016 on:
2014/30/EU, 2006/42/EC including their amendments and
complies with the following standards:
EN 60745-1, EN 60745-2-6, EN 50581:2012.
Technical file (2006/42/EC) at:
Robert Bosch Power Tools GmbH, PT/ETM9,
70538 Stuttgart, GERMANY
Henk Becker
Helmut Heinzelmann
Executive Vice President
Head of Product Certification
Engineering
PT/ETM9
Robert Bosch Power Tools GmbH
70538 Stuttgart, GERMANY
Stuttgart, 01.01.2017
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 168.
Sound emission values determined according to
EN 60745-2-6.
Vibration total values a
(triax vector sum) and uncertainty K
h
determined according to EN 60745-2-6.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
English | 11
1 609 92A 1KS | (11.11.15)
Publicité
Table des Matières
