Refilling The Boiler With Water; Cleaning And Maintenance - Euroflex EZ1 MONSTER Notice D'utilisation

REFILLING THE BOILER WITH WATER

WARNING: Let the appliance cool down 5 minutes before opening it. If the boiler is still warm,
the water may spurt out during the refilling operation causing burns. Pay attention when refilling
and unscrewing the safety cap since it may be hot and steam may come out causing burns.
Step 1: Unplug the appliance.
Step 2: Press the trigger on the handle.
Step 3: Slowly turn the safety cap counterclockwise. Let all remaining steam escape.
Step 4: Let the appliance cool down 5 minutes before refilling it with water.
Step 5: Fill the boiler using the provided funnel keeping the handle in the upright off-position.
Step 6: Firmly screw the safety cap back on by turning it clockwise.
Step 7: Insert the plug into the wall socket.
IMPORTANT
• Always use tap water to clean.
• Use tap water or dilute it with distilled water if tap water is too hard. to avoid the risk of
staining pale coloured fabrics.
• Do not add detergents, perfumes, oils or other chemical substances.

CLEANING AND MAINTENANCE

If distilled or demineralized water is regularly used there is no need to clean the boiler.
RINSING THE STEAMER
If you use tap water we reccomend you periodically rinse the floor steamer to prevent
the accumulation of calcium and scales. After 10 - 15 refilling cycles, fill the boiler with
hot tap water, shake and empty
25