Table des Matières
Publicité
SETTING THE TIME
1. Before inserting the batteries, adjust the time to 5:50 by using the Time Setting knob to rotate the hands CLOCKWISE.
2. Install two "C" size alkaline batteries according to the +/- symbols in the battery holders.
3. Set the time by using the Time Setting knob to rotate the hands CLOCKWISE. If setting the time for PM, make sure the hour hand passes through 12 o'clock noon
until the desired time is shown. While setting the time, it is normal to hear sounds from the movement or speaker. Continue advancing the time until the correct time
is shown. Once the time is set, the melody will adjust to the time selected, however, it is important that the clock movement be allowed to operate for at least one
hour for the chime sequence to become fully functional. The clock may chime out of sequence during the first hour of operation. The quartz movement is highly
accurate and has been adjusted at the factory for precise time keeping.
SETTING THE MELODY
SELECT:
Use the chime SELECT switch to select the chime melody according to the following settings:
4X4 WESTMINSTER = Westminster melody and Hour Strike on the hour. Additionally ¼ of the melody at quarter past the hour, ½ the melody at half
past the hour, ¾ of the melody at three-quarters past the hour, and the full melody on the hour.
4X4 AVE MARIA
= Ave Maria melody and Hour Stike on the hour. Additionally ¼ of the melody at quarter past the hour, ½ the melody at half past
the hour, ¾ of the melody at three-quarters past the hour, and the full melody on the hour.
WESTMINSTER
= Westminster melody and Hour Strike on the hour. No ¼, ½, ¾ melody during the hour.
BIM BAM
= Bim Bam strike on the hour (i.e. at 1 o'clock, 1 strike of "bim-bam", at 2 o'clock then 2 strike of "bim-bam", etc.) No melody.
VOLUME CONTROL
VOLUME: Turn the Volume Control Knob to adjust the volume.
SOUND:
Use the SOUND switch to select the sound options according to the following settings:
PM11:00-AM5:45 NIGHT OFF
24 Hr ON
OTHER FEATURES
MONITOR: Press the MONITOR button to demonstrate the hourly chime melody.
SET:
Advances the hour strike count without advancing the time shown on the clock. Hour strike may not match time shown on
clock after pressing the SET button.
RESET:
Resets the next hour strike count to 6:00AM. If after at least one hour, the hour strike count does not match the time:
- set the time to 5:50 by using the Time Setting knob to rotate the hands CLOCKWISE
- press the RESET button
- set the time to the desired time by using the Time Setting knob to rotate
the hands CLOCKWISE (If setting PM time, make sure the hour hand
passes through 12 o'clock noon until the desired time is shown.)
PENDULUM SET-UP (for pendulum movements only)
1. Release the Pendulum Guide from the Transport-Locking Pin by gently pushing it
sideways, allowing the pendulum guide to hang freely.
2. Hang the pendulum on the pendulum guide.
3. Move the pendulum to the far left of center and release.
4. Let the clock operate a few minutes until the pendulum settles into an even
swinging motion.
BATTERY REPLACEMENT
If the clock begins to lose time, chime weakens, or pendulum stops to swing, this
is the sign of weak or exhausted batteries. Replace with new alkaline batteries.
LIMITED WARRANTY
This warranty is our promise and commitment that our products have been manufactured using the
finest materials and have been thoroughly inspected prior to being shipped from our facilities.
Products are warranted to the original consumer or recipient to be free from manufacturing defects
in materials and workmanship under normal use, conditions and service from the date of purchase
for a period of 1 Year.
This warranty does not include: damage to product or components resulting from abuse, accident,
alteration, or climatic/environmental conditions; damage resulting from normal wear and tear,
misuse, or unauthorized repair; natural variations in wood grain or changes in surface finishes due
to aging or exposure to light. The company's obligation under this warranty shall be limited to
repairing the product or component, or at its option, replacing it with a new product or component.
A copy of the sales receipt or other comparable proof of original purchase is required to obtain
warranty service. Some states do not allow the exclusion or limitation of incidental or consequential
damages or the limitation on how long an implied warranty lasts so the above limitations or
exclusions may not apply to you. This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.
Freight Damage
By accepting our product for shipment, the carrier acknowledges that the product is in First Class
condition. By signing (or someone else signing on your behalf) to accept the shipment, you
acknowledge that the product has been received in the same First Class condition as shipped. If the
carton is crushed or otherwise damaged, instruct the driver to note the damage on the freight bill and
file a claim immediately with the carrier. For your protection, we suggest that you inspect all
merchandise at the time of delivery, before signing the Bill-of-Lading. When you or your
representative signs without noting any damage, shortages or exceptions, you accept and own the
merchandise, as delivered.
Concealed Freight Damage
Should damage be discovered after delivery, you (the consignee) are responsible for filing a written
Concealed Damage Claim with the carrier, requesting the carrier to make an inspection and create a
damage report. This must be done no later than 14 days after the delivery date. Filing this claim is
your responsibility, however, we will help you with the process and act as your advocate in reaching
a satisfactory resolution with the carrier.
THE COMPANY DISCLAIMS ANY LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY. IMPLIED
WARRANTIES ON THIS PRODUCT SHALL BE IN EFFECT ONLY FOR THE DURATION OF THE
EXPRESS WARRANTY SET FORTH ABOVE AND THEREAFTER, THERE SHALL BE NO WARRANTIES,
EXPRESS OR IMPLIED, (INCLUDING MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR
PURPOSE), ON THIS PRODUCT.
QUARTZ MOVEMENT INSTRUCTION
= turns off the chime melody and strike from 11:00PM to 5:45AM (Automatic Nightime volume shut-off)
= the chime melody and strike are always ON
OFF
= the chime melody and stike are always OFF
860 East Main Avenue Zeeland, Michigan 49464-1300
www. howardmiller.com © Copyright Howard Miller
BATTERY
PILA
PILE
BATTERIE
MONITOR
MONITOR
DIFFUSION
ÜBERPRÜFEN
SET
AJUSTE
RÉGLAGE
EINSTELLEN
SELECT
SELECCIÓN
SÉLECTION
WÄHLEN
PENDULUM GUIDE
GUÍA DEL PÉNDULO
GUIDE DU PENDULE
PENDELFÜHRUNG
SERVICE INFORMATION
Before pursuing service, ensure that all instructions provided with your Howard Miller
product have been carefully followed. These instructions will provide detailed information
to answer most questions. Contact the Howard Miller web site (www.howardmiller.com)
for a list of frequently asked questions that may conveniently resolve your problem or
answer your question.
In the unlikely event that your clock appears to be malfunctioning or requires repair, in
NORTH AMERICA please call one of our Repair Technicians at (616) 772-9131.
OUTSIDE NORTH AMERICA please call your distributor or agent.
Before calling, please have the following information available. The model number and
serial number can be found on the Product Information Label. Please also have these
instructions available at the time of your call.
Model Number: ________________________ Serial Number:
Date Purchase: ________________________ Where Purchased: ______________________
Brief Description o Problem: ______________________________________________________
_________________________________________________________________________________
1. Contact the Howard Miller Customer Service Department.
2. Have a copy of the original bill of sale or other proof of purchase or receipt date
available.
3. Have the Howard Miller model number and serial number and a complete description
of the problem available.
4. Return authorization is required from Howard Miller Customer Service prior to the
return of any product or component to Howard Miller.
You will be charged for repair services if a bill of sale or other proof of purchase date is
not provided, if instructions were not followed, if the product is beyond the Limited
Warranty period or is otherwise outside the scope of the Limited Warranty.
TIME SETTING
PARA FIJAR LA HORA
RÉGLADE DE L'HEURE
ZEITEINSTELLUNG
BATTERY
PILA
PILE
BATTERIE
SOUND
SONIDO
SON
TON
VOLUME CONTROL
CONTROL DEL VOLUMEN
COMMANDE DU VOLUME
LAUTSTÄRKENREGLER
RESET
REAJUSTE
RÉINITIALISATION
RÜCKSETZEN
TRANSPORT-LOCKING PIN
GANCHOS DE SEGURIDAD PARA TRANSPORTE
PATTES DE VERROUILLAGE
POUR LE TRANSPORT
TRANSPORTSICHERUNGSSTIFTE
_______________________
495748-R2
Publicité
Table des Matières
