Choosing The Proper Location; Installation Location Requirements - LG STYLER S3RERB Manuel Du Propriétaire

16 INSTALLATION
over the adhesive with your fingers. Wipe with
warm water and dry.
• Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue.

CHOOSING THE PROPER LOCATION

Electricity
Floor
Ambient temperature
Clearances

INSTALLATION LOCATION REQUIREMENTS

WARNING
Read all installation instructions completely before installing and operating the Styler.
It is important to review this entire manual before installing and using the Styler.
The installation requires:
 A grounded electrical outlet located within
2 ft. (61 cm) of either side of the appliance.
Install where an outlet is easily accessible.
Use an individual, grounded outlet:120 Volts, 60 Hz, AC, 15 Amps minimum.
WARNING:
Do not plug in multiple appliances in the same outlet with the S
tyler. Overloading house wiring can cause a fire hazard.
To reduce the risk of electric shock, do not install the S tyler in a wet or
damp area.
Floor must be level and solid enough to support 183 lb (83 kg).
Adjust the leveling legs to compensate for any unevenness in the floor.
Do not install on a platform or a weakly supported structure. If installing on
carpeting, see Installing on Carpeting, page 17.
Temperature must be between 50°F (10°C) and 95°F (35°C).
If the ambient temperature is too low or high, performance may be affected. Do
not install in direct sunlight or where the temperature may fall below 32°F (0°C).
Allow at least 18 in. (46 cm) in front to open the door.
Allow at least 2 in. (5 cm) on both sides and between the back of the Styler and
the wall. Allow at least 7 3/4 in. (20 cm) between the top of the Styler and any
overhanging shelves or cabinets.
If the Styler is too close to adjacent items, performance may decrease and
electricity consumption may increase.
These products can damage the surface of the
Styler.
 A sturdy floor to support the total appliance
weight of 183 lbs (83 kg). The combined weight
of any other laundry appliances should also be
considered.