Noise Data; Vibration Information; Assembly And Operation - Worx WX094 Mode D'emploi

for further details. Store personnel can assist you
and offer advice.

NOISE DATA

A weighted sound pressure
A weighted sound power
Wear ear protection

VIBRATION INFORMATION

Typical weighted vibration a
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
8
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained
Using the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
3-speed Workshop Blower
L = 77dB(A)
pA
K = 3dB(A)
pA
L = 94.4dB(A)
wA
K = 3dB(A)
wA
= 2.5m/s
2
h
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATION
Read the operator's manual
INTENDED USE
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
Note
Remove the battery pack before carrying
•
out any adjustment, servicing or
maintenance.
Make sure that ON/OFF Switch is on ''O''
•
position before assembling or removing any
accessories.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the blower tube
BEFORE OPERATION
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use. More details
can be found in charger's manual
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because of an electrical failure and
hazard will occur.
Installing & removing the battery
pack
OPERATION
Using the variable speed dial(1,2,3)
Starting & Stopping
WARNING! The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
Using the blower
FIGURE
See Fig
A1, A2
See Fig. B
See Fig. C
See Fig. D
See Fig. E
See Fig. F
EN