Assembly And Disassembly Of The Covers - GeoSmart NETZERO BW Manuel D'installation

Figure 2.3. Removing the screws fastening the heat pump to the pallet.

2.4. Assembly and disassembly of the covers

A 4 mm allen wrench is needed to assemble and disassemble the covers.
NETZERO CW Models
1. Disassemble the top front cover. Remove the screws located at the upper part and pull the cover upwards.
2. Disassemble the bottom front cover. Remove the screws located at the upper part and pull upwards.
3. Disassemble the side covers. Loosen the screws located at the front and rear and remove the cover.
4. Once the covers have been removed, the acoustic insulation panels can be removed by pulling them outwards.
GEOSMART ENERGY
Figure 2.4. Disassembly of the covers of the NETZERO CW models.
9
Installer manual NETZERO