Recommended Positioning - GeoSmart NETZERO BW Manuel D'installation

NETZERO BW Models
1. Disassemble the top cover. Remove the screws located at the rear and pull the cover upwards.
2. Disassemble the front cover. Remove the screws located at the upper part and pull the cover upwards.
3. Disassemble the side covers. Loosen the screws located at the front and rear and top and remove the cover.
4. Once the covers have been removed, the acoustic insulation panels can be removed by pulling them outwards.
▪
During cover disassembly, take care to remove the control panel cable without damaging it.
NOTE

2.5. Recommended positioning

Choose a dry place where there is no risk of frost. Avoid installation against bedroom walls or walls of other rooms where noise
emissions can be annoying. If possible, install the heat pump with the rear part pointed toward an exterior wall. Avoid installation
near a corner, since this can amplify noise emission levels.
The heat pump should be installed on a stable base that can support the total weight of the equipment and the operating fluids in its
interior. Use the adjustable legs to compensate for possible irregularities on the supporting surface.
GEOSMART ENERGY
Figure 2.5. Disassembly of the covers of the NETZERO BW models.
Figure 2.6. Positioning and levelling the heat pump.
10
Installer manual NETZERO