Black & Decker FSMH1321 Mode D'emploi page 9

Masquer les pouces Voir aussi pour FSMH1321:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Attaching accessories (Fig H)
Removing the hose and accessories
Removing an accessory
Removing the hose
SteaMitt
Attaching the SteaMitt
steam unit
Fitting a cleaning pad to the
Align the lugs on the steam nozzle (17) with the recesses
on the accessory.
Press the accessory onto the steam nozzle (17) and twist
anti-clockwise until the accessory clicks into place.
Important! All accessories, apart from the SteaMitt
which has its own hose and connector (26), must be attached
to the steam hose (16) for use.
Warning! The steam hose (16), Steam nozzle (17) and
accessories become hot during use. Allow the unit and all
accessories to cool before attempting to remove.
Twist the accessory clockwise then pull away from the
hose (16).
Press the steam hose release button (16a) on the steam
hose (16) and pull away from the hand held steam unit.
Your BLACK+DECKER
SteaMitt
sanitising and cleaning tiles, work tops, kitchen surfaces and
bathroom surfaces. This appliance is intended for indoor
household use only.
Warning! Inspect the seal between the connection point on
the hand held steam cleaner (5) and the SteaMitt
(26) before each use. If the seal malfunctions or is damaged,
please contact your nearest authorised repair agent. Do not
use the appliance.
Press the SteaMitt
hose release button on the SteaMitt
hose (26).
Connect the SteaMitt
cleaner (5) and release the SteaMitt
making sure it clicks into place.
Important! Ensure that the SteaMitt
connected to the hand held steam cleaner (5).
hose.
Fit the cleaning pad (27) to the SteaMitt
underside of the SteaMitt
Warning! The SteaMitt
cleaning pad.
TM
TM
TM
TM
TM
u
u
u
u
u
u
If steam escapes from the joint, the hose is incorrectly fitted.
Switch off, allow the unit to cool then remove and refit the
u
attaching the 'loop' velcro strips (27a) on the upper side
of the cleaning pad, to the 'hook' velcro pads (25a) on the
should not be used without fitting a
hose to the hand held
SteaMitt
(Fig. L)
(25)
has been designed for
hose
hose (26) to the hand held steam
hose release button
hose (26) is securely
(25) by
TM
TM
TM
TM
TM
TM
TM
TM
TM
(4). Press down firmly.
Note:
Use
Autoselect
Technology (Fig. R)
(Original instructions)
Note: The SteaMitt
of varying thickness. The thinnest can be used for cleaning 3D
forms such as taps etc. The thicker versions can be used for
Warning! Always use the SteaMitt
figure M, with your hand inside the protective glove.
Warning! Never attempt to use the SteaMitt
gripping it externally as shown in figure N.
This will result in scalding.
Warning! Avoid using the SteaMitt
Warning! Should a problem occur during use,
use the quick release tab to quickly remove the
SteaMitt
Warning! Do not use the SteaMitt
such as windows as damage may be caused by the
sudden change in temperature.
Warning! Never point or direct the mitt at yourself
or any other person.
Variable steam dial is disconnected when the
SteaMitt
limited.
Important! This unit will kill 99.9% of bacteria and germs
when used in accordance with the instructions in this manual
of 90 seconds.
Switching on and off
To switch the appliance on, press the ON/Off switch (1).
It takes approximately 15 seconds for the steam mop to
heat up.
To switch the appliance off, press the ON/Off switch (1).
Note: always have your hand inside the SteaMitt
press the steam button.
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
Always place the steam mop with the handle (8) supported in
the upright position when stationary and make sure the steam
mop is turned off when not in use.
Caution! Always empty the steam mop after use.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
shows various cleaning applications. They are used to select
the correct operating mode for your particular cleaning
operation.
TM
TM
TM
TM
TM
@
@
@
larger flat areas.
@
@
as shown in figure O.
@
from your hand as shown in figure P.
is fitted and subsequently the flow of steam is
and with the micro fibre pads fitted and a continuous run time
u
u
This steam mop is fitted with an Autoselect
ENGLISH
accommodates 3 types of cleaning pads
as shown in
in tight corners
on cold glass,
dial (2) which
TM
TM
TM
TM
TM
by
before you
9
TM

Publicité

Table des Matières
loading

Table des Matières