Switching On Gas Burners - Brandt TE270 Série Guide D'installation Et D'utilisation

99636361_ML.qxd 08/07/2005
2 / USING YOUR APPLIANCE
• •

SWITCHING ON GAS BURNERS

Each burner is supplied by a tap which can be
opened by pressing it and turning it in in a
counterclockwise motion.
The "l" point corresponds to closing the tap.
— Choose the desired burner by using the
symbols located near the knobs (e.g.: front left
burner ).
Your hob is fitted with a burner-lighting system
built into the knobs.
— To light a burner, press on the knob and turn
it in a counterclockwise direction
maximum setting
— Continue to press on the knob to produce a
series of sparks until the burner lights.
The setting for more moderate flame
intensities arebetween the symbol
symbol .
• •
HOB WITH GAS SECURITY DEVICE
(according to model)
The burner safety measure is a metal rod
located directly to the side of the flame.
Each burner is controlled by a tap fitted with a
safety system that, in the event of accidental
flame extinction (spills, draughts, etc.), quickly
and automatically cuts the gas supply and
prevents it from being released.
The setting for more moderate flame
intensities are between symbol
symbol .
Warning
— Hold the knob completely pressed
down for a few seconds after the flame
appears to trigger the safety system.
08:52 Page 53
to the
.
and the
and the
Fig. 01
Tip
In order to ensure the proper lighting
of the double crown burner, we suggest
that you light it before placing cookware on
it.
When a knob becomes difficult to turn, do
not force it. Request an emergency service
call for the installer.
If the flame goes out accidentally, reignite
normally following the starter instructions.
53
EN