Installing Your Appliance; Proper Positioning; Flush Mounting - Brandt TE270 Série Guide D'installation Et D'utilisation

99636361_ML.qxd 08/07/2005
EN

1 / INSTALLING YOUR APPLIANCE

Fig. 01
• • PROPER POSITIONING
Your appliance shoud be built in the surface
of a support cabinet that is a minimum of
three cm thick, made of a material that resists
heat or that is covered with such a material.
So as not to disturb movement of cooking
utensils, there should not be to the right or
left or back any obstacle within 30 cm of the
hob.
If a horizontal divider wall is positioned under
the hob, it should be placed between 10 cm
and 15 cm away from the top of the work top.
In any event, do not store aerosol cans or
containers under
compartment that may exist under the hob
(See " Safety Recommendations " chapter).
• •

FLUSH MOUNTING

To ensure that the hob and the work top are
leaktight, glue the seal provided in the front
pocket before installing the hob: Follow the
diagram (Fig. 01) .
— Remove the pan supports, the burner
covers and burner heads, noting their
08:52 Page 44
pressure in any
44
APPLIANCE
Width
56 cm
Cut
cabinet
standard
56 cm
Cut
cabinet
recommended
71 cm
Dimensions
total
a a b b o o v v e e
the work
top
55.4 cm
Dimensions
total
b b e e l l o o w w
the work
top
positions.
— Turn the hob over and carefully place it on
top of the opening in the cabinet so asnot to
damage the knobs and spark plugs.
— To ensure a tight seal between the housing
and the work top, glue the foam seal a a l l o o n n g g
t t h h e e e e x x t t e e r r i i o o r r e e d d g g e e o o f f t t h h e e h h o o u u s s i i n n g g (Fig. 02 ).
Housing
Seal
Depth Thickness
49 cm next
cabinet
48 cm next
cabinet
52.2 cm 5.5 cm
47 cm 3.4 cm
Fig. 02