Inserting Printing Cartridge - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970
Charge batteries
Only connect the device to the PC when the PCset graphic-Software was installed.
Charging at a USB hub without dedicated power supply is not possible.
Connect the Micro-USB socket of the device
f
connect the mains unit to the mains.
The green charging indicator

1.2. Inserting Printing Cartridge

CAUTION
Health risks if ink is swallowed.
Don't swallow!
f
Keep cartridge out of the reach of children!
f
Inserting printing cartridge
Depending on ink type used, different Protective Nozzle Seals are required.
Use sealing of the enclosed printing cartridge.
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
Print carriage
Release trigger button
f
Gently push the lock of print cartridge
f
can be opened.
Open print cartridge flap
f
Take new print cartridge
f
15
nozzles .
Put the jetStamp graphic 970 on a fixed flat surface.
f
Insert printing cartridge
f
Close the print cartridge flap
f
Push the trigger button
f
Print carriage
15
Fig. C

8
lights up.
Fig.

7
to position 1.
1
pushed and take the device from the base station
3
moves to the middle position.
1
.
11
.
12
from the packaging and remove protective film from the
12
.
11
.
1
.
3
moves to the home position.
9
to the mains unit with the USB cable and
A + B + D
4
.
13
to the right, until the print cartridge flap
4
.
11