Mechanical Installation - Liberty Pumps SJ10 Mode D'emploi

3

Mechanical Installation

.
SumpJet®
Note- The
3-1 For nominal backflow protection SumpJet
ASME A112.18.1/CSA B125.1.2005. Additional backflow protection must be provided by the installer to meet the requirements
of the local plumbing code or the requirements of the local water authority. As per the Uniform Plumbing Code and per the
Plumbing Codes of some states, including the State of Michigan, installation of this product requires the use of an RP (RPZ)
backflow protection device. Contact your local plumbing or water authority for more information regarding the requirements for
your specific area. The discharge of the water-powered sump pump must not to be connected to the primary sump pump. Also,
the discharge of the water-powered sump pump is not to be directly connected to the municipal drain. An air gap with a
minimum 1" gap should be used, or the discharge should be directed outside of the building, with the end of the pipe between
150 and 610 mm (6 and 24 in) above the ground or the flood level of the area receiving the discharge.
3-2
Disconnect the existing sump pump from the electrical supply before installation of the
3-3 DO NOT USE A GARDEN HOSE. Garden hose is not designed to hold municipal pressure indefinitely. It could
leak or burst and cause flooding. The
other permanent plumbing method, be used for installation. To achieve maximum performance from the
recommended that the unit is plumbed with 3/4" pipe. All water supply piping shall be made of materials and methods approved
by the local plumbing codes.
Figure 1 Typical installation
comes fully assembled. Only placement and connection is required.
®
is pre-equipped with an internal check valve certified to ASME A112.18.3-2002 and
SumpJet®
©Copyright 2014 Liberty Pumps Inc. All rights reserved
requires permanent piping methods such as copper, PEX, or CPVC, or any
SumpJet®
.
SumpJet®
it is
5