Liberty Pumps SJ10 Mode D'emploi page 7

SumpJet®
NOTE: The
need to install a check valve on the discharge pipe.
NOTE: The foot valve has a removable poppet. Where freezing
discharge pipes are a problem, simply unscrew the strainer
screen, remove the poppet and spring, and replace the strainer.
SumpJet®
The
eliminating discharge pipe freezing.
3-14 Turn the municipal water supply back on and open the shutoff valve.
Check for leaks. Test the
operational. You will need to fill the sump pit with water by garden
hose or bucket.
3-15 Re-connect primary electric sump pump to power supply.
3-16 If you want to replace the sump cover it will be necessary to add
additional holes and slots to make access for the
suction pipe and float rod. Refer to template provided in Figure (4) at
the end of the manual.
3-17 If you cannot mount the
may use a piece of wood to mount the
figure (4) at the end of the manual. There are 4 screw holes that you
can use to fasten the
wood screws. Refer to Figure ( 3 )
4
Warranty
 NOTE: Liberty Pumps, Inc. assumes no responsibility for damage or injury due to disassembly in the field. Disassembly, other than at
.
Liberty Pumps or its authorized service centers, automatically voids warranty.
Liberty Pumps, Inc. warrants that pumps of its manufacture are free from all factory defects in material and workmanship for a period of 3
years from the date of purchase. The date of purchase shall be determined by a dated sales receipt noting the model and serial number
of the pump. The dated sales receipt must accompany the returned pump if the date of return is more than 3 years from the "CODE"
(date of manufacture) number noted on the pump nameplate.
The manufacturer's obligation under this Warranty shall be limited to the repair or replacement of any parts found by the manufacturer to
be defective, provided the part or assembly is returned freight prepaid to the manufacturer or its authorized service center, and provided
that none of the following warranty-voiding characteristics are evident.
The manufacturer shall not be liable under this Warranty if the product has not been properly installed; if it has been disassembled,
modified, abused or tampered with; if the electrical cord has been cut, damaged or spliced; if the pump discharge has been reduced in
size; if the pump has been used in water temperatures above the advertised rating, or water containing sand, lime, cement, gravel or
other abrasives; if the product has been used to pump chemicals or hydrocarbons; if a non-submersible motor has been subjected to
excessive moisture; or if the label bearing the serial, model and code number has been removed. Liberty Pumps, Inc. shall not be liable
for any loss, damage or expenses resulting from installation or use of its products, or for consequential damages, including costs of
removal, reinstallation or transportation.
There is no other express warranty. All implied warranties, including those of merchantability and fitness for a particular purpose, are
limited to three years from the date of purchase.
This Warranty contains the exclusive remedy of the purchaser, and, where permitted, liability for consequential or incidental damages
under any and all warranties are excluded.
comes complete with a foot valve. There is no
will now allow water to flow back into the pit,
SumpJet®
to ensure that it is
SumpJet®
to the pump discharge pipe you
SumpJet®
SumpJet®
to the wood. Use #8x2.5" long
©Copyright 2014 Liberty Pumps Inc. All rights reserved
SumpJet®
. Cut holes as per
Figure 3
7