Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch GLM 30 Professional Notice Originale

24 | English
Cause
The laser beam output (8) and/or recep-
tion lens (7) are fogged up (e.g. due to a
rapid temperature change).
The calculated auto-sum is greater than
99,999 m.
Measurement result implausible.
Target surface reflection not distinct (e.g.
water, glass).
Laser beam output (8) and/or reception
lens (7) are covered.
Obstruction in the path of the laser beam.
The indicator remains unchanged or the measuring tool reacts unexpectedly when
a button is pressed.
Software error.
The measuring tool monitors for correct operation in every measurement. If a defect is
detected, all indicators in the display will flash. In this case, or if you are unable to rectify
an error using the corrective measures above, send the measuring tool to the Bosch
after-sales service via your dealer.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or solvents.
Take particular care of the reception lens (7), which must be handled with the same level
of care you would give to a pair of glasses or a camera lens.

After-Sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
1 609 92A 5DZ | (29.01.2020)
Corrective measures
Wipe the laser beam output (8) and/or re-
ception lens (7) dry with a soft cloth.
Divide the calculation into intermediate
steps.
Cover the target surface.
Keep the laser beam output (8) and/or re-
ception lens (7) clear.
Laser point must be fully on the target sur-
face.
Remove the batteries, reinsert them and
restart the measuring tool.
Bosch Power Tools