Retrait Et Installation Du Cadre De Verre - Fireplace Xtrordinair 864 TV 40K CleanFace Manuel D'installation

Finalizing the Installation

Retrait et installation du cadre de verre

Attention: L'appareil doit être complètement froid avant de retirer le verre.
Attention: Ne frappez pas et ne claquez pas le verre.
Remarque: Retirez la barrière avant de retirer le verre (voir page précédente). Remplacer la barrière
après avoir remplacé le verre.
Based upon the face being used, either:
a
(a) swing the access door down and remove the top grill,
(b) remove the face (unscrew or lift off - see the instructions included with the face for details).
Open the six latches holding the glass frame in place (start with the bottom three) - follow the
directions shown to the right.
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions above in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE: Make sure the glass frame is all the way in place.
© Travis Industries
You may use the included glass latch tool to unlatch the glass latch.
When done with the tool, place it on the base of the fireplace below
the concealment cover.
NOTE:
You may need to lift
the glass frame
while re-attaching.
10/20/2021 – 1481-FR
(for qualified installers only)
Top of
Firebox
Latch
Catch
(on glass frame)
43
Glass
864 40K CF Install