Transport Over Stairs; End Of Operation - diversey TASKI ergodisc 2000 Mode D'emploi

Transport over stairs

Transport over stairs should generally be carried out by two
persons.
• Switch the machine off.
• Disconnect the power supply cord from the mains socket.
Caution:
Due to the weight of the machine, there are risks involved in such
transportation!
Tripping could result in injury to an individual or damage to the
machine.
• Bring the machine into the transport position by
pressing the height adjustment lever and
swivelling the guide pillar forward until it lies in
the engine cover.
Lifting the machine
Option A: To lift the machine, hold the machine by the handle while a
second person holds the back of the housing.
Option B: To lift the machine, both persons should hold the machine by
the handle and the back of the housing.
A

End of operation

• Release the operation levers.
• To raise the pads, press the foot pedal down
until it locks into place.
• Switch the machine on by pressing the main
(ON/OFF) switch.
• Pull the power supply cord out of the mains socket.
• Bring the machine into the pad-change position.
• Remove the pad fixation (1) and the pad (2).
2
1
12
B
• Replace the pad fixation on the pad drive.
• Bring the machine into the parking position.
• Clean the power supply cord with a damp cloth and wrap it around the
machine handle and the cord hook.
Remove/change the dust bag
• Remove the cover from the dust bag
compartment.
• Remove the full dust bag.
• Insert a new dust bag.
• Clean the dust bag compartment using a damp cloth.
• Close off the dust bag compartment again with
the cover.
Cleaning the pad
• Vacuum up the dust off the pad.
Caution:
Do not tumble dry the pads!
Cleaning the machine
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
• Wipe down the machine with a damp cloth.