Black & Decker BDECS200 Mode D'emploi page 8

Assembly/Adjustment Set-Up
WARNING:
Always unplug saw
from power supply before any of the
following operations.
ADJUSTING THE DEPTH OF CUT
The depth of cut should be set according
to the thickness of the workpiece.
• Loosen the depth adjustment lever (12)
to unlock the saw shoe (4).
• Move the saw shoe into the desired
position (Figure E). The corresponding
depth of cut can be read from the depth
scale (13).
• Tighten the lever to lock the saw shoe in
place.
• Set depth adjustment of saw such that
one tooth of the blade projects below
the workpiece as shown in Figure F.
E
F
Surface of wood
ADJUSTING THE BEVEL ANGLE
This tool can be set to bevel angles
between 0° and 45°.
• Loosen the locking knob (9) to unlock
the saw shoe.
• Move the saw shoe (4) into the desired
position (Figure G). The corresponding
bevel angle can be read from the scale (14).
• Tighten the locking knob to lock the saw
shoe in place.
Tip of tooth
8
G
INSTALLING THE BLADE
• Keep the spindle lock button (16)
depressed and rotate the blade until the
spindle lock engages.
• Loosen and remove the blade retaining
screw (11) by turning the hex wrench
(15) counterclockwise (Figure H).
• Remove the outer washer (10).
• Place the saw blade (5) onto the spindle
shaft, making sure that the arrow on the
blade points in the same direction as the
arrow on the upper gaurd of the tool.
• Fit the outer washer on the spindle with
the larger flat surface against the blade.
• Insert the blade retaining screw into the
hole in the spindle.
• Securely tighten the blade retaining
screw by turning hex wrench clockwise
to tighten the blade retaining screw.
H
11
REMOVING THE BLADE
• Loosen and remove the blade retaining
screw (11) by turning it counterclockwise
using the hex wrench (15).
• Remove the outer washer (10).
• Remove the saw blade (5).
NOTICE: Never engage the spindle lock
while the saw is running. Never turn the
saw on while the spindle lock is engaged.
Severe damage to the saw may result.
WARNING:
To reduce the risk of
serious personal injury, read, understand
and follow all important safety warnings
and instructions prior to using tool.
16