Mitsubishi Electric Mr.SLIM PLA-A EA7 Série Manuel D'installation page 10

6. Electrical work
Service menu
Test run
Input maintenance info.
Function setting
Check
Self check
Main menu:
Cursor
F1 F2 F3 F4
Function setting
Ref. address Grp.
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Cursor Cursor
F1 F2 F3 F4
Fig. 6-12
Function setting
Ref. address Grp.
Sending data
F1 F2 F3 F4
CHECK
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER h
TEST RUN min
SET RESET CLOCK
Function setting
Ref. address
Unit No.
Grp./1/2/3/4/All
Monitor:
Cursor Address
F1 F2 F3 F4
Fig. 6-11
Function setting
Ref. address Unit # 1
Mode 7
Mode 8
Mode 9
Mode 10
Request:
Cursor Cursor
F1 F2 F3 F4
CHECK CHECK
CHECK CHECK
1 (Fig. 6-10)
Select "Service" from the Main menu, and press the [SELECT] button.
button.
2 (Fig. 6-11)
[F4] buttons, and then press the [SELECT]
<Checking the Indoor unit No.>
When the [SELECT] button is pressed, the target indoor unit will start fan operation.
If the unit is common or when running all units, all indoor units for the selected
refrigerant address will start fan operation.
3 (Fig. 6-12)
appear highlighted. Non-highlighted items indicate that no function settings are
4 (Fig. 6-13)
[F1] or [F2] button to move the cursor to select the mode number, and
change the setting number with the [F3] or [F4] button.
5 (Fig. 6-14)
data from the remote controller to the indoor units.
Function setting screen.
Changing the power voltage setting
1 Going to the function select mode
CHECK
button F twice continuously.
Press the
(Start this operation from the status of IR wireless remote controller display turned off.)
is lit and "00" blinks.
CHECK
temp button C once to set "50". Direct the IR wireless remote controller
Press the
toward the receiver of the indoor unit and press the
2 Setting the unit number
temp buttons C and D to set the unit number "00". Direct the IR wireless
Press the
remote controller toward the receiver of the indoor unit and press the
3 Selecting a mode
Enter 04 to change the power voltage setting using the
Direct the IR wireless remote controller toward the receiver of the indoor unit and
h
button A.
press the
Current setting number: 1 = 1 beep (one second)
2 = 2 beeps (one second each)
3 = 3 beeps (one second each)
4 Selecting the setting number
temp buttons C and D to change the power voltage setting to 01 (240
h
button A.
press the
5 To select multiple functions continuously
Repeat steps 3 and 4 to change multiple function settings continuously.
6 Complete function selection
Direct the IR wireless remote controller toward the sensor of the indoor unit and
button E.
press the
Note:
Whenever changes are made to the function settings after installation or main-
tenance, be sure to record the changes with a mark in the "Setting" column of
the Function table.
Refer to the appropriate operation manual included with each remote controller.
[F1] through
[SELECT] button to send the setting
h button A.
min
button B.
temp buttons C and D.