Fcc Caution; Remote Control Features - Zephyr Essentials Genova ZGE-E30AS Guide D'utilisation, D'entretien Et D'installation

To assure continued compliance, any changes or modif cations not expressly approved by the party

FCC Caution:

responsible for compliance could void the user's authority to operate this equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
Remote control is sold as an optional accessory. Purchase Zephyr part number: 14000005
This remote control may operate in humid environments, but not when placed on a wet surface.

REMOTE CONTROL FEATURES:

Blower On/
Blower On/
1 2
Speed Selection
Power Off
3 4
Lights On/Dim/Off
5 Min Delay Off
+
A
Replace battery door and recycle old battery.
If the remote control does not work after installation (yet the hood works correctly):
1. Place remote control on the counter near the hood (make sure a good battery is installed).
2. Disconnect power from the hood by turning off circuit breaker.
3. Reconnect power to the hood.
Follow this procedure whenever the remote control does not work.
Blower On/Speed Selection
1
By pressing , the blower is switched On. Press
three blower speeds.
2 Blowers On/Hood Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
3
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the power pack display
function is on. The blower will change to speed 1 and shut down after 5
minutes.
Lights On/Dim/Off
4
Switch lights On by pressing
The RF remote control is equipped with a magnet for easy storage. The remote
may be placed on any magnetic surface such as a refrigerator or the Zephyr
remote holder. Maximum remote control communication distance from hood is 15ft.
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
-
Follow instructions below for replacing battery.
Using a small f at head screwdriver, raise the cover of the battery door (A) in order
to access the battery compartment.
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
16
www.zephyronline.com
again to cycle through all
indicating the
once, again to dim and again to switch Off.