Zephyr Essentials Genova ZGE-E30AS Guide D'utilisation, D'entretien Et D'installation page 11

1. Determine and mark center line on wall and cabinet bottom with a pencil.
2. If the cabinet bottom is recessed, wood blocking must be installed to ensure proper
alignment of the hood with the cabinet bottom. Wood blocking should be f ush
within cabinet bottom.
3. Follow the dimensions in Fig.1 and cut-out the bottom of your cabinet to create an opening
for the hood to f t through. If you have a frameless cabinet begin the 1-9/16" measurement
(referenced in Fig.1) from front of the cabinet door. This way the front edge of the hood will
be f ush with the cabinet doors when closed, see Fig.2.
7"
7
19-
7/8"
C/L
Fig.1
front edge
glass handle
Fig.2
9
"
3/4