Intermec EasyCoder 7422 Manuel D'utilisation page 64

Table des Matières

Publicité

7422 Thermal Printer User's Guide
AutoSense Gap
Sensor Adjustment
Dump Mode Printout
48
To activate the AutoSense feature, first
place the power switch in the OFF (0)
position. Load labels into the printer (do
not use the dispenser), then press and hold
the FEED Control while placing the power
switch in the ON (1) position. Release the
FEED Control when the printer starts
feeding labels. The printer will advance 3-4
labels while performing the adjustment.
When the adjustment is complete, a status
summary label will be printed and the
printer will be placed in Diagnostic Dump
mode. Tap the FEED Control once to
switch the printer back to normal
operation. If the indicator continues to
glow ORANGE or switches to RED, refer to
Appendix A for troubleshooting
information.

Publicité

Table des Matières
loading

Produits Connexes pour Intermec EasyCoder 7422

Table des Matières