Table des Matières
Publicité
ELECTRICAL CONNECTIONS
Your MACHINE must only be connected to an
electrical supply of the same voltage and
frequency as indicated on the rating plate.
Ensure that the plug fitted to the end of the
power supply cord is suitable for your supply
socket, if not refer to the information contained
in 'Electrical Connections', or consult a quali-
fied electrician. The electrical installation from
which the supply is drawn must be maintained
to current Institute of Electrical Engineers wi-
ring regulations.
IMPORTANT
240 volt 50 Hz. machines are fitted with a 13
amp. 3 pin moulded plug. the plug is fitted with
a 10 amp. detachable fuse. The correct repla-
cement for the fuse is identified by marking or
colour
coding. Only fuses that are ASTA
approved to BS 1362 should be fitted. Never
use the plug without the fuse cover fitted.
Replacement fuse covers are available at any
electrical retail outlet.
If the available socket outlet is not suitable for
the plug supplied, the plug must be cut off and
an appropriate plug fitted. The plug thus cut off
MUST BE DESTROYED for safety reasons
before being disposed of.
Machines built for other voltages and frequen-
cies are not normally supplied with a fitted
plug.
If it is necessary to fit a plug, the wires in this
power supply cord are coloured in accordance
with the following code:
BLUE-NEUTRAL
BROWN-LIVE
DOUBLE-INSULATED MACHINES
(Only applicable to UK)
To connect the new plug:
If using a three-pin plug, do not make any
connection to the the terminal in the plug
which is marked with the letter 'E' or by the
safety earth symbol or coloured green or
green & yellow. This machine is double-insu-
lated and no earth connection is necessary.
The wire which is coloured blue must be
connected to the terminal in the plug which is
marked with the letter 'N' or is coloured black
or blue.
The wire which is coloured brown must be
connected to the terminal in the plug which is
marked with the letter 'L' or is coloured red or
brown.
If the plug to be fitted does not conform to the
above notation then consult a qualified electri-
cian.
11
Publicité
Table des Matières
