Hanging The Fan - Kichler Jade Manuel D'instruction

5. HANGING THE FAN

REMEMBER to turn off the power before you
begin.
To properly install your ceiling fan, follow the
steps below.
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counterclockwise. (Fig.5)
Step 2. Remove the ceiling mounting bracket
from the canopy by removing(and save) one of
the two screws. Loosen the remaining screw by
a half turn. (Fig.5)
Step 3. Pass the 120 volt supply wires from
the ceiling outlet box through the center of the
ceiling mounting bracket. (Fig. 6)
Step 4. Attach the ceiling mounting bracket to
the outlet box using the screws and washers
included with the outlet box. (Fig. 6)
Step 5. Remove the hanger ball from the
downrod assembly by loosening the setscrew,
removing the cross pin and turning the ball off
the downrod. (Fig. 7)
Step 6. Loosen the two setscrews and remove
the hitch pin and retaining clip from the coupling
on top of the motor assembly. (Fig. 8)
Step 7. Carefully route the electrical supply
wires and safety cable exiting the top of the fan
motor assembly through the downrod. Thread
the downrod into the coupling until the hitch pin
holes are aligned. (Fig. 8)
Next, replace the hitch pin and retaining clip.
Tighten both setscrews. (Fig. 8)
Ceiling mounting
bracket
UL Listed
outlet box
Ceiling
mounting
bracket
Hook
120V Wires
Cross pin
Hanger ball
Downrod
Supply wires
& Safety cable
Downrod
Set screws
Hitch pin
60" Jade
4
Canopy
Canopy cover
Fig. 5
Washers
Mounting screws
(supplied with
electrical box)
Fig. 6
Set screw
Fig. 7
Coupling
Set screws
Retaining clip
Fig. 8