Disposal - Zyliss 31500 Mode D'emploi

STORAGE / DISPOSAL
Zyliss-Zerkleinerer-07.indd 39
– Rinse the disks and all plastic components under the tap, using a little
detergent, and dry them carefully.
Take care when drying the sharp disks – risk of injury!
– Important: powerful cleaning agents and solvents should not be
used!
– All plastic components can be cleaned in the dishwasher.
Important: only clean components on the upper level of the
dishwasher!
Storage
To store the equipment with maximum economy and so that it will be pro-
tected from dust, we recommend the following procedures:
– Insert working container.
– Insert tamper in upper component, and then place upper component
in container upside down (the working hopper fits into the working
container, the rotary button slots into position on the drive axle and
closes when slightly turned).
– Place disks on disk holder and position on the opening of the working
container.
Warning, the disks are sharp: risk of injury!
– Remove the automatic tappet and place it with the disk holder.
– Place lower component with the bottom part upward (large opening
above the disks).
– Protect equipment and accessories from dust, dirt and humidity.
– Store the equipment in a place that is dry, free of dust and out of the
reach of children.

Disposal

– Equipment that has reached the end of its service life can be taken to
a service point to be disposed of properly, free of charge.
– If equipment has a hazardous fault, dispose of it immediately and
ensure that it cannot be re-used.
– Do not dispose of equipment with domestic waste (for environmental
reasons!).
GB

10.11.2006 23:15:11 Uhr