Zyliss 31500 Mode D'emploi page 39

4.
3.
2.
1.
Zyliss-Zerkleinerer-07.indd 37
Working with the citrus squeezer
– Important: do not connect to the power before assembling the citrus
squeezer.
– Position the working container in the grater so it snaps in place.
1. Set the catch container (element without sieve holes) on the motor
component with the opening at the top, so that it snaps in place. The
small, oval outlet is at the front. The small tooth on the back must slot
into the opening provided.
2. Place the pulp sieve on the catch container (important: edge and
opening should be above) and turn a little, until the sieve snaps in
place.
3. Then insert the anti-spray ring.
4. Place working cone on the drive so it sits.
Important: the equipment has two safety switches. Consequently
it can only be operated when the catch container and the working
container are correctly assembled!
– Before connecting the power, please make sure that the citrus
squeezer attachment is properly assembled and sits correctly.
– Before connecting the power, set the main switch to «o».
– Connect plug, first to the grater and then to the socket (230 V~).
– Set main switch to «I». The lamp lights up, and the squeezer is now
ready to operate.
– The operating button « » lights up on the operating panel.
– Cut the citrus fruit in half, and press down lightly on the working cone.
– Start the motor with switch «1» (the button you press lights up).
Note: level «2» is too fast, as it may cause splashing.
– Processing can be interrupted at any time by pressing the « » button.
Notes:
– If buttons «1» and «2» both flash, the equipment has not been
assembled properly and the safety circuit is inhibiting its function-
ing. Switch off the grater at the main switch, and reassemble.
– Never touch the rotating parts when the motor is running!
GB

10.11.2006 23:15:10 Uhr