Publicité
Cleaning.
NOTE: Please observe the illustrations on
cleaning!
1. Press the button until the device is completely
empty and there is no pressure left. Remove
the head from the bottle and pull off the
decorator tip.
2. Remove the head gasket for basic cleaning.
3. Clean all product components by hand using
warm (not hot) tap water along with a stan
dard cleaning agent. Clean the decorator tip
using the cleaning brush. Completely remove
any fat and egg white residue.
NOTE: Do not use scouring agents or abrasive
sponges/brushes.
NOTE: Do not put in the dishwasher and do not
wash in boiling water.
NOTE: The decorator tip can be removed at any
time for cleaning – simply rinse it with warm
water.
Storage.
If the iSi Whipper is not going to be filled again
immediately, leave the components to air dry
in a clean place and store the iSi Whipper in a
dismantled condition. Never store the whipper
with the head screwed on!
Troubleshooting.
Release the pressure
Place the device upright, place a towel or cloth
over the tip and gently press the button until
the pressure is gone from the iSi Whipper. Now
the head can be removed from the bottle.
If the pressure will not release, please contact
iSi or your service center.
I cannot remove the content and/or the iSi
Whipper sprays.
10
Publicité
