Section 4 − Installation; Selecting A Location; Remote Control Receptacle - Hobart Welders EZ-TIG 165I Manuel Du Propriétaire

4-1. Selecting A Location

Movement
!
Do not move or operate unit where it could tip.
Location And Airflow
18 in. (460 mm)
18 in. (460 mm)

4-2. Remote Control Receptacle

NOTICE − Use this receptacle to connect the dedicated remote control only. Connecting other types of equipment to this receptacle may damage
your machine.
8
1
805 113-A
SECTION 4 − INSTALLATION
1
18 in. (460 mm)
18 in. (460 mm)
Socket*
A
Foot Select
3
Socket Information
1 Command reference; +10 volts DC output to remote control.
2 0 to +10 volts DC input command signal from remote control.
3 Remote control circuit common.
4 15 volts DC.
6 Contact closure to 4 completes 15 volts DC contactor control
circuit.
5 Foot control select; jumper to 7 in foot control.
7 Chassis common.
1 Handles
Use Handles to lift welder; get help
if necessary.
2 2 Cart
Place welder on cart to move unit.
3 Line Disconnect Device
Locate unit near correct input pow-
er supply.
Position unit so air can circulate.
For information about sources of
high-frequency see Section 8.
For carts and caster kits see back
of book or contact your distributor.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
OM-245 020 Page 13
805 468-A