Checking The Water Tanks; Loading The Styler - LG STYLER S3 F Serie Manuel De L'utilisateur

CHECKING THE WATER TANKS

Check the water in the water tanks before use.
The water supply tank must be filled with water
before using the Styler. The Styler does not work
without water. The water drain tank should be
emptied before each use.
1 Pull the handle of each tank forward to
remove the tank and check the level of
water.
water drain tank
2 Make sure the water supply tank is filled
with water.
The full water supply tank can be used
approximately four times, depending on the
cycles used. Use clean tap water or bottled
water for best performance and longer
product life. Do not use distilled water or
reuse the water from the drain tank.
The first time the Styler is used, 2/3 of the
water in the fully filled water supply tank is
used. Less water is used in following cycles.
CAUTION
• Only use water when filling the water
supply tank. Any other substance, such
as detergent or fabric softener, may
damage the Styler.
• Use only clean tap water or bottled
water. Foreign materials in the water
may shorten the lifespan of the Styler.
• Do not use distilled water. The
water sensor may not work.
• Do not reuse the water in the drain
tank to fill the water supply tank.
3 Make sure the water drain tank is empty.
The drain tank will be filled after about three
uses. The tank fills more quickly during drying
cycles. The Styler does not work if the drain
tank is full.
• Some discoloration of the water drain tank
may occur over time. This is normal and will
not affect product performance.
water supply tank

LOADING THE STYLER

CAUTION
y Check all pockets to make sure that they
are empty. Items such as clips, pens,
coins, and keys can damage both the
Styler and your clothes. Flammable
objects such as lighters or matches
could ignite, causing a fire. Failure to do
so can result in fire, explosion, or death.
y Never dry clothes that have been exposed
to oil, gasoline, or other flammable
substances. Washing clothes will not
completely remove oil residues. Failure
to obey this warning can result in fire,
explosion, or death.
y Remove empty hangers from the moving
hanger and place them on the shelf
before starting the cycle. Empty hangers
may cause unnecessary noise, friction, and
damage to fabrics. See Storing Hangers,
page 28.
y Hang hangers in the same direction
on the moving hanger to prevent
collisions.
accessory items to use it with
shirts, dresses, suits, coats,
skirts, pants without creases
hangers
or too large for pants press, or
any item that can use a hanger
Pants Crease
pants when creases are desired
Care
sweaters, wool, knitwear,
lingerie, shoes, hats, toys, and
shelf
other clothing or items that
cannot use hangers
OPERATION 25