Flex VCE 45 H AC Manuel D'utilisation page 23

 Remove the dirt that has accumulated
on the pure air side.
 Insert new flat-folded filter.
 Close the filter door, it must lock into
place.
 Fasten the screw of the filter cover us-
ing the screwdriver in the clockwise di-
rection.
Replacing the safety filter sack
Danger
The dust that has been collected should be
transported in dust-proof containers. No re-
filling is permitted. The waste containing
asbestos is to be disposed off according to
the rules and regulations for waste dispos-
al.
Danger
Only persons trained in waste disposal are
permitted to dispose off the dust collection
container.
Illustration
 Close the suction connection, see wet
vacuuming.
 Release and remove the suction head.
Illustration
 Pull over the safety filter sack.
Illustration
 Pull out the safety sheet.
 Close the safety filter sack using the
self-adhesive flap.
 Pull the safety filter sack towards the
rear.
Illustration
 Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration
 Securely close the safety filter bag with
the attached cable tie.
 Remove the safety filter bag.
 Wipe the inside of the container using a
damp cloth.
 Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.
Illustration
 Affix a new safety filter bag.
Illustration
 Pull the safety filter sack over the con-
tainer.
 Insert and lock the suction head.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
Troubleshooting
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Note:In case of a failure (e.g. filter break-
age) the appliance must be turned off im-
mediately. The failure must be remedied
before the appliance is put into operation
again.
Suction turbine does not run
 Check cables, plugs, fuse, socket and
electrodes.
 Turn on the appliance.
Suction turbine turns off
 Empty the container.
Suction turbine does not start again
after the container has been emp-
 Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
 Clean the electrodes as well as the
space between the electrodes with a
brush.
Suction capacity decreases
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Replace the safety filter sack.
 Ensure the filter cover properly locks
into place.
 Replace the flat pleated filter.
- 7
EN
tied
23