Venting Introduction; Venting Guidelines - England's Stove Works 25-EP Mode D'emploi

Venting Introduction

This pellet stove operates on a negative draft system, which pulls combustion air
through the burn pot and pushes the exhaust air to the vent pipe and out of the building. This
unit must be installed in accordance with the following detailed descriptions of venting
techniques; not installing the stove in accordance with the details listed here can result in
poor stove performance, property damage, bodily injury or death. England's Stove Works is
not responsible for any damage incurred due to a poor or unsafe installation.
If questions arise pertaining to the safe installation of the stove, our Technical Support
line (800-245-6489) is available. Contact your local code official to be certain your
installation meets local and national fire codes and if you're uncertain about how to safely
install the stove, we recommend contacting a local NFI certified installer to perform the
installation.

Venting Guidelines

 ALWAYS install vent pipe in strict adherence with the instructions and
clearances included with your venting system.
 DO NOT connect this pellet stove to a chimney flue which also serves
another appliance.
 DO NOT install a flue pipe damper or any other restrictive device in the
exhaust venting system of this unit.
 USE an approved wall thimble when passing through a wall and a ceiling
support/fire stop when passing through a ceiling.
 ONLY use 3.0" or 4.0" Type L or Type PL pipe approved for pellet stove
venting; DO NOT use galvanized or B-Vent pipe.
 SEAL each joint of pellet vent with high temperature silicone (Part # AC-
RTV3) to prevent smoke spillage into the home.
 AVOID excessive horizontal runs and elbows, as both will reduce the draft
of the venting system and will result in poor stove performance.
 INCLUDE as much vertical pipe as possible to prevent smoke from the unit
from entering your home in the event of a power outage.
 INSPECT your venting system often, to be certain it is clear of fly-ash and
other restrictions.
 CLEAN the venting system as detailed in the maintenance section of this
manual.
WARNING: Venting system surfaces get HOT, and can cause burns if
touched. Noncombustible shielding or guards may be required.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
FREESTANDING INSTALLATION
9