Installing And Removing The Battery Pack - DeWalt DW076 Guide D'utilisation

CAUTION: Never attempt to open the battery pack for any rea-
son. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
LASER OPERATION
• Ensure that the battery is properly charged. If the "Power" LED
light is flashing, the battery needs to be charged.
• To extend battery life per charge, turn the laser off when it is not
in use.
• To ensure the accuracy of your work, check the laser calibration
often. See the Field Calibration Check section of this manual.
• Before attempting to use the laser, make sure the tool is posi-
tioned on a relatively smooth,secure surface.
• Always mark the center of the laser line or dot. If you mark dif-
ferent parts of the beam at different times you will introduce
error into your measurements.
• To increase working distance and accuracy, set up the laser in
the middle of your working area.
• When attaching to a tripod or wall, mount the laser securely.
• When working indoors, a slow rotary head speed will produce
a visibly brighter line, a faster rotary head speed will produce a
visibly solid line.
• To increase beam visibility, wear a Laser Enhancement
Glasses (not included) and/or use a Laser Target Card (not
included) to help find the beam.
• Extreme temperature changes can cause movement or shifting
of building structures, metal tripods, equipment, etc., which can
effect accuracy. Check your accuracy often while working.
• If the laser is dropped or has suffers a sharp blow, have the
calibration system checked by a qualified service center before
using the laser.
NOTE: The DW076 rotary laser has no remote control capability.
SPECIFICATIONS
Light Source
Laser Wavelength
Laser Power
Rotation Speed
Self-Leveling Range
Indoor Visible Range
Range with Detector
Level Accuracy
Power Source
Operating Temperature
Storage Temperature
Water Resistant
Usage
Altitude
Maximum Relative
Humidity
Rated Pollution Degree
Installing and Removing the
Battery Pack
NOTE: Make sure your battery pack is fully
charged before you install it.
INSTALLING THE BATTERY PACK
1. Rotate the battery adapter plate (A) so that the
applicable cut out for 9.6, 12, 14.4 volt pack
or the 18 volt pack is aligned with the battery
contacts facing the inside of the cut out.
7
Semiconductor laser diode
630 – 680nm Visible
<5mw, CLASS IIIa LASER
PRODUCT
approx. 600 rpm
± 5°
200' (61m) diameter
1500' (450m) diameter
± 1/8" per 100'
(± 3mm per 31m)
9.6V–18V D WALT batteries
E
23°F to 122°F (-5°C to 50°C)
-4°F to 158°F (-20°C to 70°C)
IPX4
Indoor and Outdoor
Up to 6560' (2000m)
95%
2
A
B