IKEA LAGAN FCF223/92 Mode D'emploi page 12

ENGLISH
Problem
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre. You can find the list at the
end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Possible cause
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the The melting water outlet does
not flow in the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open lon-
ger than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
1. Remove the
screw from the
lamp cover.
2. Pull outwards
the hook of the
lamp cover.
3. Remove the
lamp cover.
4. Replace the
lamp with one
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.
12
1
2
3