Restore Default Values: Reset - Fermax DUOX plus Mode D'emploi

RESTORE DEFAULT VALUES: RESET

The DUOX amplifier has a 'Reset' function which can be used to
restore programmed default parameters.
RESET Mapping (call button code)
1º- Reset amplifier: remove power.
2º- With the SW1 button pressed, power and maintain the SW1
button for 15 seconds. The LED will blink quickly to indicate
that button mapping has been restored.
Lock Release Times
To change the door opening times, see Voice Assisted
Configuration of Pushbutton Panels code 970048.
You can also set it by temporarily connecting a keypad (ref.
7439), (download the Direct Video Duox Panel Programming
Manual, cod. 970052, at www.fermax.com).
RESET to default parameter values (via keypad)
You can Reset the parameters to the factory default values. For
this you must temporarily connect a keypad (ref. 7439) to enter
the numeric values. Download the Duox Video Direct Panels
Programming Manual, cod. 970052 at www.fermax.com.
Pag 29