Bosch PSA 900 E Notice Originale page 16

OBJ_BUCH-1352-001.book Page 16 Thursday, November 11, 2010 3:54 PM
16 | English
Technical Data
Sabre saw
Article number
Rated power input
Stroke rate at no load n
0
Tool holder
Stroke rate control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 90 dB(A);
Sound power level 101 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting board: Vibration emission value
2
a =20 m/s , Uncertainty K=1.5 m/s
h
Cutting wooden beam: Vibration emission value
2
a =32 m/s , Uncertainty K=1.5 m/s
h
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
1 609 929 X53 | (11.11.10)
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
PSA 900 E
different accessories or poorly maintained, the
3 603 CA6 0..
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
W 900
working period.
-1
min 0 – 2700
An estimation of the level of exposure to vibra-
SDS tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
mm 28
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
mm 200
the operator from the effects of vibration such
mm 20
as: maintain the tool and the accessories, keep
mm 150
the hands warm, organisation of work patterns.
Declaration of Conformity
kg 3.5
We declare under our sole responsibility that
/II
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
20.10.2010
2
,
Assembly
2
.
Replacing/Inserting the Saw Blade
Dr. Eckerhard Strötgen
Head of Product
Certification
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Bosch Power Tools