Makita GN01 Manuel D'instruction page 10

CAUTION:
Use this tool only for soft concrete built up not so
•
long before. Using on the hard concrete may cause
nail bending or nail-driving to insufficient depth.
When the penetration amount into concrete is
•
required more than 20 mm (13/16"), driving nails
to the sufficient length may not be obtained. Nails
may be driven too shallow causing unstable
workpiece, resulting
damage to property.
Anti dry fire mechanism
This mechanism prevents the tool from firing without
nail.
Dry fire prevention automatically functions when the rest
of nails get to the last 2-3 pieces.
Jammed nailer
WARNING:
Always be sure to remove the fuel cell and the
•
battery cartridge before clearing a jam.
CAUTION:
Do not use deformed nails or nail strip. Failure to
•
do so causes poor nail feeding.
Follow the removing nail procedure and remove the
jammed nails.
013166
Remove the fuel cell, the battery cartridge and nails.
Loosen the bolt on the magazine. Remove the
magazine and remove the jammed nails.
013163
If the nails cannot be removed after performing above
method, do as follows.
Insert a small rod or the like into the ejection port and
tap it with a hammer to drive out the jammed nails from
the ejection port.
in personal injury and
1. Magazine
1
1
013227
013164
If the nails still remain in the ejection port, do as follows.
Loosen the bolts on the ejecting port by using a hex
wrench. Remove the under driver guide. And remove
the jammed nails.
Return the under driver guide and tighten the bolts after
the jammed nails are removed.
Return the magazine and tighten the bolt.
MAINTENANCE
CAUTION:
Always remove the fuel cell, the battery cartridge
•
and nails before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Maintenance after daily work
At the end of daily work, conduct an end-of-workday
routine.
These simple steps are based on maintaining the safety
and performance of the tool.
Before leaving the work site:
Remove the battery cartridge and store in a tool-
•
carrying case. Always use the tool-carrying case
for transporting and storing the tool.
Dispose of all empty cells where they will not be
•
found by children, crushed, punctured or burned.
When you get home:
Place the battery cartridge in its charger if it needs
•
charging as indicated by the red indication lamp.
Wipe the tool with a clean, soft cloth.
•
Check the filter and clean if it is dusty.
•
10
1. Under driver
guide
2. Bolt
2