Product Registration - Bio Bronpi WIFI-1 Instructions D'installation, D'utilisation Et D'entretien

The following screen will be automatically opened:
6.2.

PRODUCT REGISTRATION

To configure the stove and the module, you must click on "add stove" and fill in all the data that is requested:
- In the field "item code", enter one of the two codes that are indicated according to the stove model connected to the module. It is
important to use capital letters to enter this data:
• BRONPI AUTO: for air stoves. For example, models Dama, Leticia, Kira, Alba, Carmen, Abril, Zoe, Noa, Rita, Lola, Eva, Mayo
and so on.
• BRONPI RADIO: for stoves of the series radiofrecuency. For example, models Alicia, Agatha, Alexia, Neva, Neva-Extra,
Damasco, Clara-Ex, Olivia-Ex, Cleo-Ex.
- In the field "Serial number", enter the serial number of the stove (CE label behind the stove or in the maintenance manual).
- In the field "MAC address", enter MAC code of the Wireless module (label behind the wireless module).
- In the field "registration code" enter REG. CODE of the WIRELESS module (label behind it).
- In the field "name", assign the chosen name to the stove by the user, for example: stove ground floor, stove salon, stove kitchen, stove
house mountain, boiler1, etc.
- In the field "state", select the country where the stove has been installed.
- In the field "province", you have to enter the province.
- In the field "city", enter the location of the stove.
When there is no error in the product registration, the following screen will appear:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Stove added successfully
The stove called "LIVING ROOM" has been added successfully
Back to stove management
19 REMOTE CONTROL WIFI1 MODULE