Installation And Configuration - Bio Bronpi WIFI-1 Instructions D'installation, D'utilisation Et D'entretien

5.

INSTALLATION AND CONFIGURATION

The wireless module is ideal to work at home, through an active Wireless network connected to the internet. The device is supplied with two
adhesive strips to fix it to a flat surface close to the stove (stand, wall and so on.), it must not be installed in areas exposed to direct heat or
transmitted by radiation, the maximum temperature of use of the module is 50 ° C.
To install the module, you must follow the next steps:
1.- Connect the module to the stove with the supplied interconnection cable and the RS232 adapter, the WIFI module must be connected to
the electric power network through the external power supply facilitated
In the case of stoves without a serial port, the Wireless module must be connected directly to the electronic board in the CN13 connector
using the interconnection cable, there is no need of using the RS232 serial port adapter:
In the first start-up, the led light C is on and holds permanently in a green sort of colour. The led E "access point" flashes for a few seconds,
wait for it to be on and fixed. If the LED E continues flashing, it means that the WIFI-1 kit does not have Wireless network signal, so you will
have to change the location of the module to get a better signal.
The LED E on and fixed in orange color means that the module has created the wireless network:
The MAC address is a unique sequence of numbers, typical of the Wireless module and indicated on the label on the back of the device.
2.- Connect to the Wi-Fi network of the "Bronpi-WIFI�MACaddress" module, looking for it with your computer, tablet or Smartphone. The
network is freely accessible and serves only to configure the module; once configured the network will disappear.
To make the connection you do not need to enter either the username or the password.
With the device connected to the network created by the WIFI module, proceed as follows:
3.- Open the Internet browser and in the address bar, type http://192.168.1.1 to open the main page of the web server contained in the WIFI
module. The browser displays the following page:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Stove connection through RS232 connector
Power supply 12V
PE
CN9
"Bronpi-WIFI�MACaddress"
xx:xx:xx:xx:xx:xx
REG. COD. xxxxxx
16
CN7
MAC ADDRESS
REGISTRATION CODE
REMOTE CONTROL WIFI1 MODULE