Bio Bronpi WIFI-1 Instructions D'installation, D'utilisation Et D'entretien page 17

Click on "Wifi Configuration":
And the following screen is displayed, you must enter the data of the home internet connection of your home.
Select one of the Wireless networks detected by the module that are displayed on the page. Enter the password for the Wi-Fi network in the
password field.
Click to "Connect" to be able to sabe the data and finish the configuration.
After a few seconds, the following message will appear to indicate that the connection will be lost since, from that moment, the wireless
module will restart in client mode connected to the home router and the free wireless network that was used for the configuration will
disappear.
After this step the LED LIGHTS D and F will blink several seconds until they remain fixed (on), if, on the other hand, the flashing of the LED
LIGHT F continues for more than 60 seconds, repeat the configuration of the module making sure that all data have been set correctly.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 17 REMOTE CONTROL WIFI1 MODULE