User And Product Registration; User Registration; Product Registration - Bio Bronpi WIFI-1 Instructions D'installation, D'utilisation Et D'entretien

6.

USER AND PRODUCT REGISTRATION

6.1

USER REGISTRATION

Once you have downloaded the BRONPI HOME application, you must
proceed to register. To do this procedure, click on SUBSCRIBE. You will
have to enter an email address as well as a password that you choose to
use to access the application. This password can therefore be different
from your email address and be easy for you to remember. The password
must be at least 8 characters long. You must accept the processing of your
personal data and click on REGISTER.
6.2

PRODUCT REGISTRATION

In order to configure the stove, you must click on "+".
You must then choose the option "external module" and proceed to connect the module to the stove as well
as to the power network according to chapter 5 of this manual; the application itself will remind you how to
do this. You should also bear in mind the MAC number, the REG CODE number which you will find on the
back of the wifi module as well as the serial number which you can find in the instruction book of the stove
and on the CE label on the back of the stove:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
In your email you will receive a 6-digit
numerical code that you must enter in the
next screen to confirm the subscription by
pressing ACTIVATE. Check all the inboxes
of your personal mail, including the spam
or junk mail folder. If you have entered the
code correctly, you will receive a message
that the registration has been successful:
Once registered, the following screen
will appear informing you that you do not
have any stove registered, so you should
proceed to register your stove:
18 REMOTE CONTROL WIFI1 MODULE