Position And Print Tone Fine Adjustment; Fine Adjustment - Oki LE840 Guide De L'utilisateur

2. PRINTER SETUP
2.9 Position and Print
Tone Fine
Adjustment
Power ON
Power OFF
Hold down [MODE]

2.9.1 Fine Adjustment

USER SYSTEM MODE
<1>RESET
<2>PARAMETER SET
<3>ADJUST SET
<4>LAN/WLAN
This section describes how to fine adjust a print start position, cut/strip
position, reverse feed amount, print tone, and ribbon motor torque.
When a fine adjustment is required, follow the procedure below.
ONLINE Mode
[PAUSE]
PAUSE state
Hold down [RESTART]
User System Mode
Contents of the Fine Adjustment Menu
Menu Parameter
Adjust set FEED ADJ.
CUT ADJ.
BACK ADJ.
X ADJUST
TONE ADJ. (TRANS.)
TONE ADJ. (DIRECT)
RBN ADJ. <FW>
RBN ADJ. <BK>
THRESHOLD <REFL.>
THRESHOLD <TRANS.>
The printer driver's properties screen also has Parameter Fine Adjustment
menu.
E2-51

2.9 Position and Print Tone Fine Adjustment

Reset
•
Parameter setting (⇒Section 2.6.2)
•
Fine adjustment (⇒Section 2.9)
•
LAN/WLAN (⇒Section 2.6.3)
•
BASIC (⇒Section 2.6.4)
•
Z-MODE (⇒Section 2.6.5)
•
AUTO calibration (⇒Section 2.6.6)
•
Dump mode (⇒Section 2.6.7)
•
Log (⇒Section 2.6.8)
•
Adjusts the feed amount to the
print start position
Adjusts the cut or strip position.
Adjusts the reverse feed amount.
Adjusts the print position in X
coordinate (horizontal direction)
Adjusts the print tone for thermal
transfer printing.
Adjusts the print tone for direct
thermal printing.
Adjusts the ribbon take-up motor
drive voltage.
Adjusts the ribbon feed motor
drive voltage.
Sets a fine adjustment value for the
threshold for the reflective sensor
(Black mark sensor).
Sets a fine adjustment value for the
threshold for the transmissive
sensor (Gap sensor).
NOTE: