Oki LE840 Guide De L'utilisateur page 32

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
NOTE:
Pre-strip function is automatically
enabled when the print speed is set to
10 ips or faster. However, the print
speed is corrected depending on the
EX I/O parameter setting, as follows.
EX I/O: TYPE 1
10 ips (203 dpi)
8 ips (300 dpi)
EX I/O: TYPE 2
Specified speed
(4) FW/BK ACT.
 MODE1
The printer waits for next issue after 13.7-mm media
has been fed forward.
 MODE2
When thermal transfer and cut mode are selected, the
printer feeds 6-mm media backward, then waits for
next issue after 3-mm media has been fed forward.
From this position, the printer starts the on-the-fly
printing for next issue. The 3-mm distance to the
home position is fed at 3 ips.
(5) HU CUT/RWD
Setting for using the Rewinder in the batch or strip issue modes.
 OFF
Rewinder is not used.
 ON
Rewinder is used.
(6) RBN SAVE
RIBBON save, Head up related parameter are included in system
menu.
However, these function will not be supported by LE840/LE850.
Therefore these parameter setting will be ignored and no effect.
(7) PRE PEEL OFF
Select whether to activate the pre-strip function. When this parameter
is set to ON, the top edge of a label is separated (pre-stripped) from
the backing paper before the label is printed. This function is intended
to make the strip issue easier in the case of labels that are hard to strip
due to the label density, strength of the adhesive used, or the print
speed.
 OFF
Disables pre peel off
 ON
Enables pre peel off
(8) BACK SPEED
Select back feed speed.
In strip issue a back feed speed of 3 ips may cause the correct distance
not to be fed due to a lack of torque, slippery media surface, etc. In
such cases reduce the back feed speed to 2 ips to ensure the correct
feed amount.
 STD
3ips
 LOW
2ips
(9) TYPE OF RIBBON
Select type of ribbon.
When a coating side of the ribbon is the outside, chooses CSO.
When a coating side of the ribbon is the inside, chooses CSI.
 CSO
Coated side out
 CSI
Coated side in
E2-18
2.6 Printer Setting