Basic Program Setting; Enabling Z-Mode - Oki LE840 Guide De L'utilisateur

2. PRINTER SETUP

2.6.4 Basic Program Setting

USER SYSTEM MODE
<2>PARAMETER SET
<3>ADJUST SET
<4>LAN/WLAN
<5>BASIC

2.6.5 Enabling Z-Mode

USER SYSTEM MODE
<3>ADJUST SET
<4>LAN/WLAN
<5>BASIC
<6>Z-MODE
The following table shows the contents of the Basic program setting
menu.
Contents of the Basic Program Setting Menu
Menu Sub menu
BASIC BASIC
FILE MAINTENANCE
TRACE
EXPAND MODE
(1) BASIC
Select whether to enable the BASIC program.
 OFF
Disables BASIC program.
 ON
Enables BASIC program.
(2) FILE MAINTENANCE
The block number and BASIC program file name (up to 12 characters)
stored in the BASIC program storage area are displayed. If the file name
exceeds 12 characters, the overflowing characters are not displayed.
When no file is stored, a hyphen ("-") is displayed in place of the file
name.
(3) TRACE
Allows you to enable tracing in the BASIC program.
 OFF
Disables tracing the BASIC program.
 ON
Enables tracing the BASIC program.
(4) EXPAND MODE
The printer switches the mode to execute the BASIC program.
The Z-Mode menu allows you to select whether or not to enable the Z-
Mode .
(1) Z-MODE
 OFF
 ON SETTING OFF
 ON SETTING ON
E2-25
Z-Mode is disabled.
Z-Mode is enabled. BASIC system mode
program is not started automatically.
Z-Mode is enabled. BASIC system mode
program is started automatically.
2.6 Printer Setting