System Mode - Oki LE840 Guide De L'utilisateur

2. PRINTER SETUP

2.6.9 System Mode

How to enter the System Mode
Power ON while holding down
[FEED]&[PAUSE]
Power OFF
Power ON while holding down
[MODE]
The System Mode consists of the following menus.
<1>DIAG.
Used to check and print the printer system information and
maintenance counter status.
<2>PARAMETER SET ( Section 2.6.2)
Used to set the parameters for each printer function.
<3>ADJUST SET ( Section 2.9)
Used to fine adjust the print position, cut position, print tone, etc.
<4>TEST PRINT
Used to perform print tests.
<5>SENSOR ADJUST
Used to check the sensor statuses and set each sensor.
<6>RAM CLEAR
Used to perform a RAM clear. DO NOT USE this menu.
<7>INTERFACE ( Section 2.6.10)
Used to set the interface parameters.
<8>BASIC ( Section 2.6.4)
Used to set the function of basic program when it is loaded to the
printer.
<9>FOR FACTORY
Used for an in-process inspection. DO NOT use this menu.
<10>RFID
Used to set RFID related parameters. ( see Installation Manual in each
RFID kit)
<11>RTC ( Section 2.6.11)
Used to set the date and time of the real time clock, enable or disable
the low battery check, and choose a real time renewal timing.
<12>Z-MODE ( Section 2.6.5)
Same as BASIC
<13>USB MEMORY ( Section 2.6.12)
Used to copy data to/from USB memory.
<14>RESET
Used to reboot the printer.
How to exit the User System Mode
Select <14>RESET menu to reboot the printer.
E2-30
2.6 Printer Setting
System Mode