Important Safety Instructions - Remington HC5015 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
At regular intervals the Blade Set should be removed and cleaned.
Note that if the blades are not correctly aligned then cutting efficiency will be impaired.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
100593_REM_IFU_HC5015_21L.indd 3
100593_REM_IFU_HC5015_21L.indd 3
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
EVERY SIX MONTHS
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade
set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fitted by slotting the long grooved
edge of the blade onto the two white plastic guide ridges and then seating the blade over
the plastic actuator bar. The fixed blade is fitted with the raised profile pointing outwards
and fixed with the 2 screws.
CAUTION: Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
Unplug the charge adaptor from the power outlet when fitting or removing attachments,
or while cleaning the product.
Always store this appliance in a moisture-free area.
Do not wrap the cord around the appliance.
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the shaver with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via the
®
Remington
Service Centre.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
3
11.08.10 21:20
11.08.10 21:20

Publicité

Table des Matières
loading

Table des Matières