Important Safety Instructions; Protect The Environment - Remington PG400 Mode D'emploi

ENGLISH
Be sure to move the unit slowly when performing this operation and to keep the hair roots at
the base of your head out of the way of the trimmer.
TO REMOVE HAIR FROM NOSE AND EAR (Diagram 6 & 7)
Attach fine trimmer attachment.
Insert the personal groomer gently into nostril or ear.
Gently move the groomer in and out of the nostril or ear and at the same time rotate.
Avoid inserting the cutting unit more than 6mm into your nostril or ear.
TO REMOVE HAIR FROM EYEBROWS (Diagram 8)
Attach fine trimmer attachment.
Gently guide cutting unit to stray, unwanted hairs along the eyebrow line or protruding
from the eyebrow itself.
To remove the hairs completely lower onto the skin and move over desired area.
Use slow and well-controlled movements.
ATTACHING AND REMOVING THE TRIMMER COMB ATTACHMENT
NOTE: Always ensure the personal groomer is switched off before changing any attachments.
To remove, hold the personal groomer with one hand and turn the trimmer head anti-
clockwise with the other.
To attach, hold the personal groomer with one hand and turn the trimmer head clockwise
with the other.
Tips for best results
Beard, moustache and sideburn hairs should be dry.
Avoid using lotions before using your personal groomer. Comb your hair in the direction
that it grows.
Remove trimmer comb attachment if you are: defining hairline edges such as sideburns,
trimming the nape of your neck, trimming your beard line on front of neck.
CARE FOR YOUR PERSONAL GROOMER
CLEANING AND MAINTAINING YOUR PERSONAL GROOMER
AFTER EACH USE
1.
Turn the personal groomer off.
2.
Gently brush the remaining hairs away/rinse under warm water from the guide comb and
trimmer blade.
CLEANING CAUTIONS
Only the guide comb attachment and trimmer blade may be removed from the product for cleaning.
Cleaning should only be done with a soft brush, such as the brush supplied with the product.
4
080189_REM_IFU_PG400_18L.indd GB_4-GB_5 080189_REM_IFU_PG400_18L.indd GB_4-GB_5
ENGLISH
Only use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their blades.
Do not submerge in water as damage will occur.
STORAGE
Always store this appliance and cord in a moisture-free area. Do not store it in
temperatures exceeding 140°F (60°C).
Do not wrap the cord of the charging adaptor around the appliance.
Suitable for cleaning under water

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE,
OR INJURY TO PERSONS:
An appliance should never be left unattended when plugged into a power outlet.
WARNING: Detach the hand-held part from the supply cord before cleaning it in water.
WARNING: The parts that have to be fixed must be installed so they cannot fall into water.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the product with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our
International Service Centres.
Charge, use and store the product at a temperature between 15°C and 35°C
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.

PROTECT THE ENVIRONMENT

This appliance contains an environmentally friendly rechargeable Nickel Metal Hydride
battery. Do not dispose the appliance or the battery in the household waste as restrictions
exist in most countries. Adhere to national or local regulations for collection and disposal
that apply to your specific location. In case you are required to remove the battery from
the appliance for separate disposal see the instructions in the 'Battery Removal' section on
how to open the housing.
5
10.04.2008 23:12:15 Uhr 10.04.2008 23:12:15 Uhr