Installation; Standard Installation - Stiebel Eltron DHF 13 C Manuel D'utilisation Et D'installation

INSTALLATION

Installation
Oversink installation
2
1 Cold water inlet
2 DHW outlet
10. Installation

10.1 Standard installation

- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter "Installation / Instal-
lation / Installation options":
- Power cable on finished walls
- Connecting a load shedding relay
- Water installation on finished walls
Opening the appliance
c om pa c t c ontr ol
co m pa ct co n tr
f Turn the cap anticlockwise. Remove by pulling it forward. f
f Undo the screw. f
f Pivot open the appliance cover. f
Preparing the power cable
160
≥ 30
22 |DHF-C
Fitting wall mounting bracket and appliance
1
1 Wall mounting bracket
2 Threaded stud
3 Threaded bush
f Remove the wall mounting bracket.
f Mark out the drill holes with the installation template (in the
f Drill the holes and secure the wall mounting bracket with
f Fit the wall mounting bracket.
f Mount the appliance on the threaded stud.
f Push the back panel firmly against the wall. Secure the back
Installation with offset tiles
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance with the nut on the threaded stud.
3
f
f
centre section of these instructions). If the appliance is to be
installed with water connections on finished walls, also mark
out a fixing hole in the lower part of the template.
f
2 screws and 2 rawl plugs. The screws and rawl plugs are
not part of the standard delivery.
f
f
f
panel using the threaded bush. You can compensate for a tile
offset with the nut on the threaded stud.
≤12
2
1
f
Push the back panel firmly against the wall. Secure the back
panel using the threaded stud.
1
2
www.stiebel-eltron.com