VALPES VT+ Manuel D'installation page 23

EN
Multipin connector
1 Seal
2 Removable connector
3 4 x M3x10 screws
4 4 x CHC M6x30 Stainless steel A2 screws
5 3 x ISO M20 x 1,5 cable glands
6 Connector cover
To wire the actuator, unscrew the 4 CHC M6x30
screws, and the 4 M3x10 screws. The wiring can be
realized without tool, just raising the strips in front of
each pin.
For the reassembly, make sure that the seal is cor-
rectly positioned in its groove to ensure tightness.
DSBA3600 • Rév. 05/11/2020
1
2
3
5
4
6
23