Table des Matières
Publicité
OUTER ENTRANCE PANEL: ASSIGNING PUSHBUTTONS TO EACH BUILDING
DESCRIPTION
In compounds with several inner buildings, before being able to make a call from the external point of entry to the different dwellings,
it is necessary to tell the system which pushbuttons correspond to each of the inner buildings. Pushbuttons must be assigned to the
different buildings from the entrance panel of the external point of entry.
This information is stored in the non-flash memory of the audio unit of the external panel. If the audio unit of the external panel is
subsequently replaced, do not forget to re-assign pushbuttons to buildings.
For compounds with several external points of entry, pushbuttons must be assigned to buildings at each of the points of entry.
PREVIOUS STEP: ORDER OF ASSIGNING
The pushbutton panels are formed of compartments of one or two rows of pushbuttons. Each compartment is joined to the next by
connectors, except for the last compartment which is joined to the audio unit.
When assigning pushbuttons to the different buildings, it is necessary to begin with the bottom row of the first compartment of the panel
and to finish with the top row of the compartment which is connected to the audio unit.
By doing this, the right pushbutton of the first compartment will be assigned to the first dwelling of building number 1, while the left
pushbutton of the last compartment will be assigned to the last dwelling of the last building of the compound (i.e. the building with
the highest number).
An example is shown below.
2 - W I R E
D O O R
11
Audio unit
External point of entry
E N T R Y
S Y S T E M S
39
CC1
30
GRF-302
V
cod. 9610044
BUS
12 12c
18 SC1
SC0
22
B3 B2 B4 B5
IN
Publicité
Table des Matières
